(edited by squallaus.8321)
Crossfire low FPS for triple monitor setup
Crossfire low FPS for triple monitor setup
in Account & Technical Support
Posted by: Farming Flats.5370
Most of the games profile are in the driver but sometime it stop to work.
Have you tried to make a custom profile for the Gw2 Client and force Crossfire ?
yes.
its low frame rate because crossfire is enabled actually. it goes down to 7 frames per second. if I run it without crossfire it gives 30 – 40 frames per second running on a single card.
I then try other games like hitman absolution crossfire works just fine.
I also tried forcing gw2 to run 32 bit version vs 64 bit version via commandline. both the same.
(edited by squallaus.8321)
Thanks Anet for fixing this so quickly with the new build that came out a few hours ago. Now when in crossfire mode for my 3 monitor setup the frames per second doesn’t drop to 7 anymore and is performing better than a single graphics card. An improvement from 30 to 40 fps vs 40 to 50fps Although I feel crossfire mode could do better still than it currently is as I’ve noticed both graphics cards aren’t being fully utilized. I’m not sure if this is a drive issue or if its a gw2 client thing. But I do remember 1 year ago my gw2 used to fully utilize both graphics cards (as in they are 100% busy ).
On a side note, for triple monitor setup the Glider bar seem to be located on the right monitor instead of the center monitor. I will make another thread in the bug section so it is easier for u to treack.