I have a problem with the SAB Shield
before even opening the thread i knew it was about the t3 gloves.
yes it looks hideous but had you used the preview, you would have known before
the purchase. its too bad there are only few shields, that don’t have clipping problems with those gloves
its not only these glvoes and its not only that shield.
my charr warrior has that problem with the majority of shields.
on my charr engineer however the shield is floating in the air, several cm from his arm away ._.
Gunnar’s Hold
Simple solution: change your gloves to less protuding ones.
before even opening the thread i knew it was about the t3 gloves.
yes it looks hideous but had you used the preview, you would have known before
the purchase. its too bad there are only few shields, that don’t have clipping problems with those gloves
The preview is really bugged right now. Before i had the SAB shield i had the AC shield and it looks without problems but in the preview looks awful.
The point is though that you can still see where the spikes on the gloves stick through.
Charr and shields are horrible… Just got the Fractal Shield on my Guardian. Not even gonna use it… It’s in the center of my arm and clips tremendously through my gloves and even shoulders (see attachment). Was going for Flameseeker Prophecies, but the preview of that was horrible too.
I guess Charr aren’t meant to wield shields :-S Hope they will look into it someday though, kinda ridiculous you can wear weapons that bug your model.
(edited by Morrar.1764)