Guild Wars 2

Is it just me but sometimes the Cleansing burst water field does not appear?

Are you running AMR? AMR does not reset cleansing burst.

I figured out what is the problem, when you use cleansing burst, you need to wait for 2-3 seconds before it spouts out water, then you can blast it.

This doesnt make any sense, since cleansing burst has no cast time.

I think it is bugged, the water field from pressing 6 2 times takes a while to appear.

Just tested… Water field can be blasted immediately. Did it 20 times.

GrandHaven.1052:

Just tested… Water field can be blasted immediately. Did it 20 times.

Man i think Its my latency,,, My healing turret takes like some seconds before it spins to spout water. Meaning, to turn it into a water field.

PS: I am doing 6 6 F1

I did the same

Try it like this: 6 – 6666666666666666 – F1

:D Just spam the heal skill a few times. I normally press it 2-4 times and then bow the turret up.

Turrets have rotations. You can see the healing turret animation, every few seconds. Between the animation the turret cannot be activated immediately. The turret will overcharge after the next animation. This means, either you blast him b4 the first animation starts (be quick) or you missed it and the overcharge comes after 2-3 sec.

You’ll get used to overcharge and blow it up, don’t worry. It’s basic engi stuff Even our healskill needs 3 keys xD

But don’t use this method mindlessly: You have more personal heal over time if you overcharge the turret and then pick him up again immediately! So only overcharge and blow him up when you need aoe heal for allies or burst heal for yourself.

Turret blast finishers are at your location btw, so you might aswell use the turret, overcharge it, leave it be and blast a fire field a few seconds later.

Questions? ^.^